BARTSHARP 183 Dual Action Gravity Feed Airbrush - Perfect For Cake Decoration
We have taken all that we have learned from recent years and teamed up with a top manufacturer, highly endorsed by international airbrush artist Chuck Bauman, to create our own brand and extensive range of airbrushes.
The BARTSHARP 183 Airbrush is a traditonal pen style with dual action and gravity feed .
It comes fitted with a quality 0.3mm needle, nozzle and nozzle cap. This set up is for general purpose spraying and will allow you to create a hair line spray width up to approximately 28mm. However it can also be fitted with a 0.5mm needle/nozzle set for creation of finer lines or detail. Alternatively it can also be fitted with a 0.8mm neelde/nozzle set which is ideally suited to those wishing to spray slightly thicker mediums, such as with cake decoration. This larger size set up optimises a smoother paint flow and will help to prevent clogging and splatter associated with the use of smaller needle and nozzle.
Dual action: push down on the trigger for air and pull back, on the trigger, to release paint.
The BARTSHARP Airbrush 183 incorporates a new nozzle and nozzle cap design which has been specifically developed to handle slightly thicker mediums.
These new nozzles are a complete change from the standard design making nozzle change and airbrush cleaning a breeze as they simply push into the airbrush body cap and are held in place by screwing the nozzle cap down. The new design nozzles also have a Teflon bush which prevents paint from escaping from behind the nozzle and is also impervious to highly aggresive paints.
The below image shows how the new design nozzle is much larger compared to a standard airbrush nozzle.
The below image shows how the new design nozzle cap (right) which allows the nozzle to push fit into place and is much larger when compared to a standard airbrush nozzle cap (left).
As you would expect we have all of the spare that you will need icluding:
The BARTSHARP Airbrush 183 comes with three fully interchangeable cups:
2cc, 5cc (with push fit lid) & 13cc (with push fit lid)
Your BARTSHARP Airbrush 183 is also fitted with a needle adjust screw on the rear handle. Adjusting this screw allows you control how far the needle is able to move back which, in turn, allows you to create the same thickness line over and over again.
The air inlet is 1/8BSP which is the most regularly used size for airbrushes and air hoses alike. (BSP means British Standard Pipe and describes the thread pitch whilst 1/8 is equal to 9.35mm (approx)
We have a limited number of these particular airbrushes.