We have teamed up with a top manufacturer to produce our own range of airbrushes.
Our manufacture has been reviewed by Airbrush Technique Magazine and famous airbrush artist Chuck Bauman:
“High Quality and Extremely Low Priced“
“They are easily as good as the famous expensive airbrushes but these are a tenth the cost!“
Your BARTSHARP Airbrush 180 is dual action and gravity feed. It comes fitted with a 0.2mm needle, nozzle and nozzle cap.
The BARTSHARP Airbrush 180 can also be fitted with 0.3mm and 0.5mm airbrush needle, nozzle and nozzle cap.
Dual action feature: simply push down on the airbrush trigger to release air and pull back on the airbrush trigger to release paint.
Careful control allows for the creation of very detailed design work and lines as fine as 1mm or less.
The maximum spray area is approximately 28mm (depending on distance from work).
The BARTSHARP Airbrush 180 is constructed from metal, has a 9cc paint cup and a 1/8BSP male air inlet threaded valve.
1/8BSP is approximately 9.35mm but is sometimes referred to as 1/8th inch.
The BARTSHARP Airbrush 180 is fitted with an adjustable needle stop at the rear of the handle.
This feature allows the airbrush artist to create lines of an equal width as it controls how far the needle can be pulled back from the nozzle.
The BARTSHARP Airbrush 180 can be used at air pressures between 15 – 50 PSI and is suitable for use with many airbrush compressors.
They are a direct fit for any airbrush compressor in our Royal Air Brush Compressor range.
Please see our compressor page which are also available as complete airbrush and compressor kits.
The BARTSHARP Airbrush 180 is fitted with a Teflon Needle Packing Bush which is highly impervious to solvent based paints (spares are available within our airbrush spares section).
It is also fitted with rubber o-rings which can be affected by solvent based paints. The level of affect depends on the strength of the solvent, exposure time and how well the airbrush is cleaned after use and storage.
We stock a fantastic range of replacement O-ring sets which are very low in price should you wish to use solvent based paint.
Please see our airbrush spares section for replacement o ring sets.
As authorised stockists of Iwata Airbrushes we have a number of Iwata Airbrushes which are fully resistant to solvent based paints. However, these air brushes are priced in excess of £250.
The BARTSHARP Airbrush 180 is ideal for airbrushing: Scale Model Painting, Fishing Lures, Makeup, Airbrush Body Art, Cake Decoration, Custom Automotive Painting, T-Shirts and Textiles.
We back up our range of airbrushes with a complete range of airbrush supplies, spares and replacement parts.